Black Jack™ propellant vacuum mixed and cast into P/N 03165L extruded plastic tubing with the following specifications:
Net propellant weight: 62.5g Click here
for a full-size propellant data sheet.
May be used with RCS 54mm high power Experimental Motor Kits™ (EMKs), also fits 03356 and 03357 delay insulator tubes, 02032, 02035, 02040 paper liners and 01950 phenolic liners.
Burning rate is approximately 1/8" per second at motor operating pressure,
and approximately 1/32" per second during the delay phase at ambient pressure.Propellant
may be cut with a hobby knife and drilled by hand or with non-sparking equipment operating at 500 RPM or less. DO NOT
use high-speed saws or cutters to machine propellant. Notice:
This product is intended for use in a rocket motor configuration of your own design. RCS Rocket Motor Components (RCS), Inc. products are sold "as-is" and no warranty, suitability or fitness for any particular application, either expressed or implied, is made regarding RCS products. Since we cannot control the storage, transportation and
use of our products, once sold we cannot assume any responsibility for product storage, transportation or usage. RCS shall not be held responsible for any personal injury or property damage resulting from the handling, storage or use of its products, including any damage to AeroTech or third-party rocket motor hardware. The buyer assumes all risks and liabilities therefrom and accepts and uses RCS products on these conditions. Note: Your state may provide additional rights not covered by this warranty. For use by certified flyers 18 years of age or older.